Model PDR™
Installation Instructions
10
ADJUSTMENTS
TENSION ADJUSTMENTS
Vertical Tilt Tension Adjustment
1.
With display mounted, check for desired vertical tilt
tension.
2.
Adjust the Centris Select
TM
knob until desired vertical
tilt tension is obtained. (See figure 10)
Figure 10: Centris Select
TM
Adjustment Knob
3.
To lock the mount at the desired vertical tilt, tighten
the vertical tilt lock screw. (See figure 11)
Figure 11: Vertical Tilt Lock
Lateral Tilt Tension Adjustment
CAUTION:
Overtightening lateral adjustment will
cause excessive wear and may distort adjustment
components.
1.
Using a 9/16” wrench (not provided), slightly tighten or
loosen lateral tilt tension adjustment nut
(See figure 12).
2.
Mount the display and check for desired tilt tension.
3.
Repeat Steps 1 and 2 until desired tilt tension is
obtained.
Rotational Tilt Tension Adjustment
1.
If necessary, loosen or tighten bottom rotational tilt
tension adjustment nut (See figure 12).
2.
Mount the display and check for desired rotational tilt
tension.
3.
Repeat Steps 1 and 2 until desired rotational tilt
tension is obtained.
Figure 12: Lateral and Rotational Adjustment
Swing Arm Adjustments
The dual swing arms are shipped installed in the center
of the top and bottom mounting brackets, which is the
standard mounting configuration.
The top and bottom mounting brackets have slotted
holes, allowing for lateral adjustment of the dual swing
arms.
After the top and bottom mounting brackets have been
installed between two wood studs 16” on center, the
swing arms can be adjusted or moved off center,
depending on the location of the mount, the size of the
display, and the lateral movement needed to rotate the
display.
Centris Select
TM
Adjustment Knob
Vertical Tilt
Lock Screw
Rotational Tilt
Adjustment Nut
Lateral Tilt
Adjustment Nut