Model PDR™
Installation Instructions
6
Install the Mount
Mounting the top bracket
WARNING:
Improper installation can result in serious
personal injury!
1.
With an assistant, lift and hang the PDR on the two
lag bolts and washers previously installed on the wall.
(See figure 2)
2.
Make sure washers are installed in front of the top
bracket, not behind the bracket.
3.
Slide the PDR into the desired position on the wall
and tighten the two lag bolts.
Mounting the bottom bracket
1.
Mark the two mounting holes in the bottom mounting
bracket (See figure 3). Make sure to align the holes
parallel to the holes drilled in the top bracket.
2.
Drill two pilot holes in the wall studs, as follows:
•
If using 5/16” lag bolts, use a 7/32” drill bit.
•
If using 3/8” lag bolts, use a 9/32” drill bit.
3.
Install two lag bolts and two washers into the pilot
holes.
•
If you used a 7/32” drill bit, use 5/16” lag bolts and
5/16” washers.
•
If you used a 9/32” drill bit, use 3/8” lag bolts (not
supplied) and 3/8” washers (not supplied).
4.
Tighten the two lag bolts.
Figure 2: Mount PDR on Lag Bolts
Figure 3: Mount Bottom Bracket on Wall
Mount (Hang) the PDR on Lag Bolts
Use Lag Bolts and Washers to Fasten PDR to the Wall
.
