Installation Instructions
PAC780/782/784
7
14. Position removed base of cart/stand to reattach to column
extrusion.
15. Install removed button head cap screws through removed
washers, holes in cart/stand, column base mount bracket
(E) and into outer extrusion of cart/stand. (See Figure 8)
IMPORTANT ! :
Partially install each screw until gas
spring is compressed before tightening screws.
Figure 8
16. Stand cart/stand in upright position. Inner extrusion should
be fully extended.
17. Pull down inner extrusion to desired height.
18. Tighten knob on back of column extrusion to secure pin into
corresponding notch at desired height.
19. Mount display onto cart/stand according to cart/stand
installation instructions.
Height Adjustment
NOTE:
Height should be adjusted with the weight of the display
or equipment mounted on the cart/stand.
1.
Loosen knob on back of column. (See Figure 9)
2.
Adjust height to desired level. (See Figure 9)
3.
Tighten knob on back of column at corresponding pin hole.
(See Figure 9)
Figure 9
back of outer extrusion
(E)
base of cart/stand
removed washers
removed screws
15
1
2
3
