Installation Instructions
PAC527 Series
11
2.
Loosely attach required conduit and conduit connectors,
switch boxes, outlets, etc (not included) to PAC527 to
enable fitting into the wall opening. (See Figure 7)
Figure 7
3.
Feed conduit attached to PAC527 through cut-out in wall
and insert PAC527 into wall opening. Tighten component
connections.
4.
Drill pilot holes (at least 2 on each side of PAC527) into
studs through mounting holes in PAC527.
•
Wood studs: use 3/16" drill bit
•
Steel studs: use 1/4" drill bit
5.
Install PAC527 to studs using four 1/4 x 2-1/2" Phillips flat
head screws (A) and four 3/8" flat washers (D) through
PAC527 and pilot holes. (See Figure 8)
Figure 8
NOTE:
If installing in a stud wall BEFORE the drywall is
installed, remove outer flange from PAC527 before
installing the PAC527. (See Figure 9)
Figure 9
(C x 4)
2
Use four 06 x 3/8" Phillips
screws (C) and four 06-32"
nuts (B) to assemble switch
box from either inside or
outside the PAC527.
(A) x 4
5
(D) x 4
4
x 2 (minimum)
each side
