Installation Instructions
ODMLT
7
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the ODMLT up to (and
including) the display does not exceed 175 lbs (80 kg).
1.
Place the display on the wall plate (A) by hooking the hooks
of the brackets (B and C) in the top of the wall plate. (See
Figure 7)
2.
Secure the display by sliding the latches, one on each side,
inward. As the latches are slid in, it will lower and catch the
bottom hook and secure the television in place. (See Figure
7)
3.
If desired, install self tapping screws (not provided) and/or
padlocks (not provided) for additional security. (See Figure
7)
Figure 7
Tilt Adjustment
1.
Adjust tilt tension adjustment knobs to desired tension. (See
Figure 8)
2.
Adjust tilt of display by pulling the top of display away from
the wall until desired tilt position is reached. (See Figure 8)
3.
Tighten tilt tension adjustment knobs to secure tilt position.
(See Figure 8)
Figure 8
Display Removal
To remove display:
CAUTION:
Disconnect power and audio/video cables
before removing the display from its wall mount.
WARNING:
The display is heavy and extremely fragile.
Exercise caution when removing the display from the mount
to avoid equipment damage or personal injury.
1.
If applicable, remove the self tapping screws (not provided)
and/or padlocks from both sides of the wall plate. This
hardware provides security. (See Figure 9)
2.
Slide the security latches out on both sides to disengage the
display from the wall plate. (See Figure 9)
3.
With an assistant, lift the display up and off the wall plate to
remove the display from the wall. (See Figure 9)
Figure 9
x 2 (optional)
3
3
1
1
2
2
tilt adjustment knobs
2
2
x 2
1
3
2
2
