Installation Instructions
ODMLT
5
ASSEMBLY and INSTALLATION
INSPECT MOUNT BEFORE ASSEMBLY
1.
Carefully inspect the mount components for shipping
damage.
2.
If any damage is apparent, call your carrier claims agent
and do not continue with the installation until the carrier has
reviewed the damage.
NOTE:
Read all assembly instructions before starting the
installation process.
Wall Plate Installation
IMPORTANT ! :
The ODMLT mounts are designed to be
mounted to a 2" x 4" wood studs (16" or 24" on center) wall with
a maximum covering of 5/8" thick drywall, plywood, OSB,
fiberboard, buffalo board or other similar sheathing materials.
IMPORTANT ! :
The ODMLT mounts may be installed to a
bare 8" concrete wall if 5/16 x 3" Buildex® Tapcon® anchors
with Blue Climaseal® coating (not included) are used in place of
lag bolts (D) provided.
Wood Stud Installation
WARNING:
It is the responsibility of the installer to verify
that the structure to which the mount is anchored will safely
support five times the combined load of all attached
components and equipment.
1.
Determine a suitable mounting location and lift the wall plate
(A) into mounting position on wall.
2.
Using a small nail or screw (not provided) in the center hole,
lightly support the wall plate at the mounting location. (See
Figure 1)
3.
Level the wall plate (A) and drill 7/32” pilot holes for
anchoring the wall plate. Holes must be drilled at the center
of wood studs. (See Figure 1) or (See Figure 2)
4.
Using four 5/16 x 3 1/2” lag bolts (W) and four 5/16” washers
(X), install the wall plate (A) on the wall. (See Figure 1) or
(See Figure 2)
Figure 1
Figure 2
5.
Slide the latches out on the wall mount in preparation for
installing display. (See Figure 3)
Figure 3
16" studs installation
(W) x 4
4
3
7/32”
(X) x 4
x 4
(A)
(W) x 4
4
3
7/32"
(X) x 4
x 4
24" studs installation
(A)
5
5
