5
2. CD Stud Mode
2-1. Summary
This machine is for Capacitor Discharge Stud Welding, the weldable range is Ø3- Ø8mm. Stud materials
are soft steel, stainless steel, aluminum, titanium (Ti), brass and copper screw. Stud Welding time is about
3/1000s-6/1000s. Stud Welding time will not damage the base metal including sheet metal.
2-2. Attention
(1) Input power is AC110V 15A.
(2) Turn “off “ the switch when not using the machine.
(3) Turn “off “ the switch when connecting or removing cables on the machine.
(4) The machine maintenance and repair must turn “off “ the switch after 5 minutes.
(5) The stud clamp is located inside the stud welding torch. The inside diameter of stud clamp must be suitable
for the stud screw. Do not use a worn stud clamp.
(6) Stud welding may cause welding arcs and metal spatter, protect yourself with appropriate safety protection
and goggles.
(7) Make sure there are no flammable materials in the work area.
(8) The machine must use the required stud screws.
(9) Pleases contact the manufacturer for the following situations:
mechanical failure, reducing or increasing the torch cable length, exchanging the standard equipment.
2-3. Stud welding
Contact type: apply to soft steel, stainless steel, aluminum, titanium (Ti), brass, and copper.
Diagram 1
1.The stud screw press
the base metal
3. Stud welding complete
2. electric discharge,
start arc
Secure the stud welding position. Press the torch trigger, press down, and the stud screw will be welded on the
base metal immediately. Electric discharge, stud welding, and recharge will process automatically and safely.
Traditional methods such as rivets, lock screws, and common welding can damage the base metal.
Summary of Contents for Multi-Spot M22AL
Page 4: ...4 Illustration Of Working Principle ...
Page 14: ...14 Notes ...
Page 15: ...15 Notes ...
