Installation Instructions
MTTU
7
Figure 4
5
(E-Q) x 4
(R) x 4 (if necessary)
(S or T) x 4 (if necessary)
(U or V) x 4 (if necessary)
(B)
(C)
locking flag in open position
Display Installation
1.
Lay display face side down on a level, non-abrasive surface.
Lay down a cloth if necessary to avoid scratching the
screen.
2.
Position left and right interface brackets (B and C) over
holes in back of display to determine which holes will be
used for installation.
NOTE:
Interface brackets should be positioned so that the
diamond hole in the bracket is located halfway between
the installation holes in order to ensure proper weight
distribution. Brackets may need to be expanded to tilt
position in order to expose installation holes.
NOTE:
Cable management pull straps should be easily
accessible underneath the display. Length of straps can
be adjusted if necessary.
NOTE:
Spacers may not be required depending on the type of
display being mounted. They will typically only be used
with recessed or bump-out back screens.
3.
Determine which screws to use to connect interface
brackets to display. Use the screws that fit into the holes on
the back of the display. Make sure screws can make at least
three full turns into mounting holes. If not, select longer
screw from hardware kit.
4.
Determine which washers and shoulder washers to use with
the corresponding screw. Refer to table below for details.
5.
Install four button head cap screws (E-Q) through required
washers (R) and shoulder washers (S or T), interface
brackets (B and C), spacers (U or V) and into holes on back
of display. (See Figure 4)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1). ALWAYS use two people and proper
lifting techniques when installing display.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the MTTU up to (and
including) the display does not exceed 100 lbs (45.4 kg).
NOTE:
Make sure locking flags are in the open position before
attaching display to wall plate. Flags are shown in the
open position in Figure 4.
NOTE:
Display can be adjusted horizontally as long as guide
hooks are securely attached to wall plate.
IMPORTANT ! :
If spacers are required, be sure to use
screws that are longer than the spacers but of the same
diameter!
6.
While supporting both sides of display, lift display up to the
wall plate on the wall.
Screw Size
Washers
Shoulder Washers
M4
use R
use S
M5
use R
use S
M6
none
use T
M8
none
none
