MTAPU
Installation Instructions
6
Figure 4
5.
Drill one 5/16" pilot hole at each marking.
6.
Install an anchor (D1) into each pilot hole using a hammer.
7.
Use two 5/16 x 2-1/2" lag bolts (D2) and two 5/16" flat
washers (D3) to attach top of mount to anchors in wall.
8.
Mark the attachment points for the lower mounting slots.
(See Figure 4)
9.
Drill one pilot hole at each marking for lower mounting
holes. (See Figure 4)
10. Install an anchor (D1) into each pilot hole using a hammer.
11. Use two 5/16 x 2-1/2" lag bolts (D2) and two 5/16" flat
washers (D3) to attach the mount to the wall through the
lower mounting holes. (See Figure 4)
12. Slide rails to approximate center of screen location.
Attaching Upright Brackets to Display
1.
Vertically align the center of the uprights (B and C) with
center of screen. (See Figure 5)
NOTE:
The diamond-shape opening in the uprights (B and C)
corresponds to the vertical center of the upright.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
2.
Select correct screws, spacers (if necessary) and washers
from the hardware bag (F) and attach brackets to back of
display. (See Figure 5)
Figure 5
Switching Upright Brackets (Optional)
If an installation situation makes adjusting the location of
upright brackets necessary, there are several options.
1.
The wall bracket may be adjusted side to side at the points
of attachment. (See Figure 6)
2.
The location of the left and right upright brackets may be
switched, with the knobs on the MTAP upright brackets
facing the inside of the mount. (See Figure 6)
7 11
(D2) x 4
(D3) x 4
8
5
6
4
9
x4
(D1) x 4
10
2
Center of
Upright
(C)
(B)
(F13 or F14)
(F1 - F11) x 4
(F12) x 4
