MSP-WLB/D SERIES
Installation Instructions
10
WL11D and WL12D
Standard Installation
1.
Loosen clamp screw until enough space is created between
clamp and mount to allow for desk mounting. (See Figure
16)
NOTE:
If space is limited behind desk (i.e. against wall, etc.),
remove lower piece of clamp and two screws holding it
to the mount and reattach parts prior to Step 3! (See
Figure 17)
2.
Place mount on top of desk at desired mounting location.
(See Figure 16)
3.
Tighten clamp using clamp screw until mount is securely
fastened to desk. (See Figure 16)
Figure 16
Figure 17
Grommet Hole Option
NOTE:
MSP-WLB11C and MSP-WLB12C mounts may be
installed directly to grommet holes between 1 1/4” and
2 1/2” in diameter. If grommet hardware (R-T) is used,
they can be installed to grommet holes between 3/8”
and 2 1/2” in diameter.
Direct Installation
1.
Remove lower piece of clamp from assembly by removing
two button head cap screws holding piece to assembly.
(See Figure 18)
2.
Install remaining part of clamp through grommet hole. (See
Figure 18)
Figure 18
3.
Reattach removed piece of clamp and screws to assembly.
(See Figure 19)
4.
Tighten clamp using clamp screw until mount is securely
fastened to desk. (See Figure 19)
Figure 19
1
2
3
desk
2
x 2
1
x 2
3
