MCD Series
Installation Instructions
6
Figure 4
Removing Display
1.
Disconnect all power/audio/video cables.
2.
Remove bolt or padlock from faceplate (if used).
(See Figure 5)
NOTE:
The pin may have been used as a more permanent
locking device. If so, remove nut and pin and move
from the lower holes to the upper holes.
3.
Pull back on flag on upper mounting hole and press pin
down into "Open" position. (See Figure 5)
WARNING:
THE DISPLAY MAY WEIGH IN EXCESS OF
40 LBS EACH! Always use two people and proper lifting
techniques when installing or positioning display.
4.
Carefully lift display from mount.
5.
Lift up on pin and place flag back against faceplate to return
it to "Closed" position. (See Figure 5)
Figure 5
Adjusting Display
CAUTION:
Watch for pinch points. Do not place fingers
between moveable parts.
4
5
To use as a more
permanent lock, remove
pin and nuts and move
to lower holes.
A padlock or bolt may
be placed through latch holes
2
1
4
Remove bolt
or padlock
if used
Pin in
"Closed"
position -
Move to
"Open"
position to
remove
display
Pin in
"Open"
position -
Move to
"Closed"
position
after display
is removed
