LW46/47/48/49/50/55UxP
Installation Instructions
8
1.
Determine the center of the wall bracket, and where it
should be located on the wall. (See Figure 2)
NOTE:
For wood or steel stud walls, use a level and mark the
two uppermost locations over studs for attachment a
minimum of 16" apart and a maximum of 24" apart.
(See Figure 2)
•
For maximum stability in a wood or steel stud wall,
mount the hinge side of kiosk as close as possible to a
stud.
NOTE:
For concrete walls, use a level and mark the two
uppermost locations for attachment as far apart as
possible to provide maximum stability. (See Figure 2)
Figure 2
NOTE:
For wood or steel stud walls, use a level and mark the
two uppermost locations over studs for attachment a
minimum of 16" apart and a maximum of 24" apart.
(See Figure 2)
NOTE:
For concrete walls, use a level and mark the two
uppermost locations for attachment as far apart as
possible. (See Figure 2)
2.
Drill one pilot hole (see Table 1 for size) at both locations
marked in Step 1 (See Figure 2) and follow fastener
information (appropriate for wall type) located in Table 1.
IMPORTANT ! :
Refer to
Fastener Installation Methods
(located in
Appendix
at end of Installation Instructions)
for details on installing product into various wall types.
Figure 3
3.
Partially install fasteners into wall, but do not completely
tighten to wall.
4.
Hang wall bracket, aligning upper mounting slot clearance
holes over fasteners and adjust side-to-side for proper
location. (See Figure 3)
5.
Tighten fasteners to secure wall bracket to wall at upper
mounting slots.
6.
Drill six remaining pilot holes (see Table 1 for size) at
attachment locations and follow fastener information
(appropriate for wall type) located in Table 1. (See Figure 3)
7.
Tighten six fasteners to secure wall bracket to wall at middle
and lower mounting slots.
x 2
1
2
Wall
bracket
Uppermost attachment area
5
6
x 2
7
[24" on-center attachment
shown as example only]
Clearance
holes
Mounting
slots