LW46/47/48/49/50/55UxP
Installation Instructions
10
7.
Place hinged frame onto back of flat panel and match the
VESA pattern on flat panel to the hinged frame mounting
slots. Also match the threaded studs in outer frame to the
hooks on the hinged frame. (See Figure 7)
8.
Use selected screws (BA-BL), washers (BO--if required),
and spacers (BM, BN--if required), to connect hinged frame
to back of flat panel. (See Figure 7)
Figure 7
NOTE:
The outer frame depth may be adjusted between
3" - 5" to make room for a variety of different flat panel
thicknesses. (See Figure 8)
•
This outer frame adjustable depth can also be used to
make more space between the back of the flat panel
and wall for AV component storage.
•
The 4 Phillips screws removed in Step 1 can be
replaced with four 10-24 x 2-3/4" Phillips screws (CD)
for larger depth adjustments.
Figure 8
9.
Tighten thumb nuts over threaded studs in four locations on
the hinged frame. (See Figure 8)
10. Replace and fasten four Phillips screws which were
removed in Step 1,
OR
replace the removed screws with
four 10-24 x 2-3/4" Phillips head screws (CD) to allow for a
larger depth adjustment of the outer frame. (See Figure 8)
11. Carefully lift (using two people) the outer frame with
attached flat panel.
12. Keeping the outer frame at a 90° angle against the wall,
slide the outer frame so that hinge pins are above hinges.
13. Lower outer frame to engage hinge pins into hinges. (See
Figure 9)
Figure 9
14. Close outer frame door and add 10-24 x 3/8" button head
security screw (CA) in hole below latch to lock door. (See
Figure 9)
NOTE: Use universal washer (BO)
(BO)
(BM and/or BN)
8
(BA-BL) x 4
Outer
frame
ONLY with M4, M5 or
M6 screws.
9
Thumb nuts x 4
10
Previously
(CD) x 4
removed
OR
[Flat panel not shown]
Hinge pin
Hinge
13
12
14
(CA x 1)
Outer
frame
Door must be closed before
Door
open
security screw (CA) is added