LCM2X1U / LCM2X1UP
Installation Instructions
10
Attaching Mount to CPA Extension Column
CAUTION:
WATCH FOR PINCH POINTS! Do not place
fingers between moveable parts.
1.
Insert two 5/16 x 3/4" set screws (W) into back of ceiling
mount (CC). (See Figure 4)
Figure 4
2.
Slide ceiling mount (CC) up from below onto installed
column (not included). (See Figure 5)
3.
Tighten two 5/16" set screws installed in Step 1 against
column.
4.
Slide bottom stop collar (AA) onto installed column, lining up
holes in collar with holes in column.
Figure 5
5.
Install two 5/16" x 1" self-tapping screws (U) through two
5/16" flat washers (V), bottom stop collar (AA), and into
installed column. (See Figure 5)
6.
Install and tighten 5/16" x 3/4" set screw (W) into bottom
stop collar (AA). (See Figure 5)
7.
Loosen two installed set screws (W), and slide ceiling
mount down extension column until it rests on the bottom
stop collar (AA).
8.
Retighten two 5/16" set screws (W) against column. (See
Figure 6)
Figure 6
Attaching Interface Brackets to Display
1.
Lower the latch mechanism on each interface bracket (EE).
(See Figure 7)
Figure 7
(W) x 2
1
(CC)
2
(CC)
4
6
5
(U) x 2
(V x 2)
(AA)
(W) x 1
8
(W) x 2
(EE)
1
Latch
mechanism
