KRA227
Installation Instructions
6
ASSEMBLY AND INSTALLATION
1.
Carefully remove display from existing mount, following
instructions included with mount.
2.
Loosen lock nut and 3" button head cap screw located in
arm to remove arm from mount. SAVE ALL HARDWARE
AND MOUNT ARM EXCEPT 3" SCREW AND PLASTIC
SPACERS! (See Figure 1)
Figure 1
3.
Attach single monitor arm assembly (A) to original mount
base using one 5/16-18 x 3 1/8” button head cap screw (J),
steel washers from existing mount, 1/2” spacer (M) and
pivot pin, pivot pin spacer and 5/16” lock nut all from existing
mount. (See Figure 2)
NOTE:
If two steel washers removed in Step 2 are lost or
damaged, replace with the extra two washers (G).
4.
Reattach original mount arm (removed in Step 2) using one
5/16-18 x 3 1/8” button head cap screw (J), one plastic
washer (E), two stainless steel washers (G), one pivot pin
(K), one pivot point spacer (F), and one 5/16” lock nut (L).
(See Figure 3)
Figure 2
Figure 3
x 1
2
2
x 1
(discard)
(discard)
(A)
Steel
washers
3
x 1
(J)
3
(M)
or (G) x 2
4
4
(L) x 1
(J) x 1
(F)
(K)
(A)
(G) x 2
(E)
