Installation Instructions
KRA227
7
DISPLAY INSTALLATION
1.
Remove quick release faceplate from KRA227 by pulling
quick release lever and sliding faceplate off. (See Figure 4)
Figure 4
2.
Carefully place display face down on protective surface.
3.
Connect faceplate to display.
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x14mm screws (B) through corresponding holes on
faceplate and into the mounting holes on the display.
(See Figure 5)
Figure 5
For recessed mounting hole installation:
•
Place four spacers (D) on top of mounting holes on
back of display. (See Figure 6)
•
Using Phillips screwdriver, carefully install four
M4x25mm screws (C) through corresponding holes on
faceplate, spacers (D) and into the mounting holes on
the display. (See Figure 6)
Figure 6
4.
Position display with faceplate attached above KRA227.
(See Figure 7)
5.
Slide faceplate onto KRA227 head until quick release tab
clicks into place. (See Figure 7)
Figure 7
Adjusting Rotation of Faceplate
The faceplate may be rotated 90° in either direction for either
landscape or portrait use.
1.
(Optional)
Rotational adjustment may be locked by
fastening face plate in place using one 10-24 x 1/4" button
head cap screw (H) into back of faceplate. (See Figure 8)
2.
Use the 3/16" hex key (P) on the button head cap screw to
adjust rotational tension, as necessary.
Figure 8
3.
Refer to Adjustments and Cable Management information
in the original mount installation instructions for further
information.
Quick release lever
1
1
KRA227
(B) x 4
quick release
faceplate
(for flush mounting holes)
3
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
5
KRA227
(H)
1
