Installation Instructions
JWP-210
8
Recess Mount Centris Bracket to Display
To recess mount Centris bracket:
1. Lay display down on a flat surface.
CAUTION:
Make sure surface is clean and
free of dirt and debris before laying display down.
2. Select four screws M4 x 20mm screws (80) and four
spacers (130) from parts bag.
3. Place four spacers (130) over mounting holes on
back of display (see Figure 5).
4. Align mounting holes on Centris bracket with spacers
installed on display.
5. Install four screws M4 x 20mm screws (80) to attach
Centris bracket to display.
6. Tighten
screws.
7. Refer to “ATTACH MOUNT TO WALL BRACKET”
section on page 11.
INSTALLATION
(200mm x 100mm)
Attach VESA Plate to Display
1. Lay display face down on a flat surface.
CAUTION:
Make sure surface is clean and
free of dirt and debris before laying display down.
2. Place six spacers (120) over six mounting holes in
display as shown in Figure 6.
3. Attach VESA Plate (20) to display using six
M4 x 16mm flat head screws (70).
4. Tighten
screws.
Attach Display to Centris Bracket
1. Start two M4 x 8mm Phillips pan head screws (50)
into top mounting holes on VESA Plate (20).
2. Align mounting holes on Centris bracket with screws
installed in Step 1 (see Figure 7).
3. Install remaining two M4 x 8mm Phillips pan head
screws (50) into bottom mounting holes of VESA
Plate (20).
4. Tighten
screws.
5. Proceed to “ATTACH MOUNT TO WALL BRACKET”
section on page 11.
Figure 5.
Recess Mount Centris Bracket to Display
Figure 6.
Attach Interface Bracket to Display
(200mm x 100mm)
Figure 7.
Attach Display to Centris Bracket
Display
120
70
20
Display
130
80
Centris Bracket
20
50
