Installation Instructions
JWP-210
9
INSTALLATION
(200mm x 200mm)
WARNING:
It is the responsibility of the
installer to use the correct diameter and length of
fastener to attach interface to back of display.
Failure to do so may cause damage to the display or
personal injury.
Attach VESA Plate to Display
1. Lay display face down on a flat surface.
NOTE:
Make sure surface is clean and free of dirt and
debris before laying display down.
2. Place four spacers (130) over four mounting holes in
display as shown in Figure 8.
3. Depending on mounting hole size and depth, attach
VESA Plate (20) by selecting applicable screws size,
as follows (see Figure 9):
a. Use four M4 x 20mm pan head screws (80) and
square holes to attach VESA Plate (20). Or,
b. Use four M6 x 20mm pan head screws (90) and
round holes to attach VESA Plate (20). Or,
c. Use four M6 x 30mm pan head screws (100) and
round holes to attach VESA Plate (20). Or,
d. Use four M6 x 45mm pan head screws (110) and
round holes to attach VESA Plate (20).
4. Tighten
screws.
Attach Display to Centris Bracket
1. Start two M4 x 8mm Phillips pan head screws (50)
into top mounting holes on VESA Plate (20). See
Figure 10.
2. Align mounting holes on Centris bracket with screws
installed in Step 1.
3. Install two remaining M4 x 8mm Phillips pan head
screws (50) through bottom mounting holes of
Centris bracket, and into VESA Plate (20).
4. Tighten
screws.
5. Proceed to “ATTACH MOUNT TO WALL BRACKET”
section on page 11.
Figure 8.
Attach Interface Bracket to Display
Figure 9.
VESA Plate Mounting Holes
Figure 10. Mount Display to Centris Bracket
Display
130
80,90, 100 or 110
20
M4 Screws
M6 Screws
50
Centris
Bracket
20
