Installation Instructions
JWP-210
12
CABLE MANAGEMENT
WARNING:
Make sure your cables do not run
through a pinch points. Do not put your fingers
between movable parts.
For cable management (not shown), connect and
secure power/audio/video cables, making sure to
leave sufficient slack to allow for movement of the
display.
ADJUST LATERAL TENSION
To adjust Lateral Tension:
1. Move arms laterally to check for desired tension.
2. Using a 3/16” hex wrench slightly tighten or loosen
lateral tension adjustment bolts (see Figure 16).
3. Repeat Steps 1 and 2 until desired tension is
obtained.
ADJUST PITCH TENSION
To adjust Pitch Tension:
1. Tilt display to check for desired tension.
2. If pitch tension in Centris Bracket requires
adjustment, perform the following steps:
a. Remove Display from Centris Bracket.
b. Using a 3/16” hex wrench, slightly tighten or
loosen pitch adjustment bolt to adjust Centris
Bracket as needed (see Figure 17).
c. Reinstall
display.
3. Repeat Steps 1 and 2 until desired tension is
obtained.
Figure 16.
Adjust Lateral Tension
Figure 17.
Adjust Pitch Tension
Lateral Tension Adjustment Bolt
Pitch Adjustment Bolt
