IR10
Installation Instructions
6
Changing System Codes
Settings are changed by a combination of remote button
presses and partially disassembling the box to change specific
jumper settings.
NOTE:
For changing what the box expects to receive, you
need to remove the housing and remove a jumper (J5).
1.
Remove four Phillips screws from housing and remove
housing cover. (See Figure 4)
2.
Remove jumper. (See Figure 4)
3.
Replace housing cover and four screws removed in Step 1.
NOTE:
This will switch the IR-10 over to the 82 system code.
The remote control will also need to be switched over.
(See Table 1-2)
Figure 4
Changing System Code for the Remote
1.
Press and Release Key 3 + 7 (Enter Setup Mode)
2.
Press and Release Key 8
3.
Press and Release Key 9
4.
Press and Release Key 10 - LED Blinks Twice <Quick>
5.
Select System Code - See Table Below
6.
Press and Release Key 2 - LED Blinks 4 times <Quick>
(Exit Setup Mode)
Table 1-2: Remote Control System Code
System Code
Press + Release
6E (Default)
8
82
8,8
1
1
3
x 4
2