FCA802
Installation Instructions
6
NOTE:
Refer to Table 1 and dimension drawings on page 3 to
determine the extension level based on extension
distance from mount center.
Table 1:
Below Wall Mount
5.
(For
maximum extension
) Use #10-32 x 3/8” button head
cap screw (P) and small washer (J) to secure adapter plate
(E) to main bracket (B). (See Figure 5)
6.
(For
maximum extension
) Use two #10-24 lock nuts (G) to
secure upright bracket (A) to main bracket (B) and adapter
plate (E). (See Figure 5)
Figure 5
7.
(For
minimum/intermediate extension
) Use two #10-24
lock nuts (G) to secure upright bracket (A) to main bracket
(B) and adapter plate (E). (See Figure 6)
NOTE:
Minimum configuration is shown below. Several
intermediate configurations are possible depending on
which holes are used.
8.
(For
minimum/intermediate extension)
Use 1/4-20 x 5/8”
hex head flange bolt (N) and center washer (F) to secure
upright bracket (A) to main bracket (B). (See Figure 6)
Figure 6
Attaching Shelf to Cart/Ceiling Mount
IMPORTANT ! :
If installing to a 2x1 display cart using
the FCA623 accessory, proceed to “Installing to FCA623
Accessory” Section (Step 6).
1.
Use two 1/4-20 x 1/4” button head cap screws (M) and two
large washers (H) to secure shelf bracket (C) to main
bracket (B). (See Figure 7)
2.
Slide main bracket (B) onto front of cart/ceiling mount head
assembly until shelf bracket (C) rests on top of head
assembly. (See Figure 7)
Figure 7
Extension distance from center of mount (in.)
12.9-15.2
Minimum
15.2-17.7
Intermediate
17.7-19.2
Maximum
(Below wall - maximum)
(E)
(B)
(A)
(J)
(P)
5
(G) x 2
6
(G) x 2
7
(B)
(A)
(N)
8
(Below wall - minimum)
(E)
(F)
holes to
use for intermediate
configurations
(rear view)
(C)
2
(M) x 2
1
(H) x 2
(B)
(Below cart/ceiling - Standard)
