FCA113
Installation Instructions
6
Installing to a Concrete Wall
1.
Determine the center of the TV screen, and where it should
be located on the wall.
2.
Line up the notches on bracket (A and B) with center of
screen marking to determine vertical center. (See Figure 1)
3.
Measure up 9.2" (233.7mm) from the center point to mark
location of the upper mounting slots. (See Figure 1)
4.
Using a level, mark the wall through both upper mounting
slots. (See Figure 3)
IMPORTANT ! :
The minimum distance between
fasteners must meet the minimum distance requirements
for the mount to which it is being attached.
WARNING:
INSTALLING THE FCA113 INTO
UNDERRATED OR DAMAGED CONCRETE CAN LEAD TO
SERIOUS INJURY OR DAMAGE TO PRODUCT! When
installing into concrete, only install the FCA113 into concrete
at least 8" in depth or into 8"x8"x16" concrete blocks! Never
install the FCA113 into cracked, chipped or flaking concrete.
IMPORTANT ! :
The FCA113 accessory is designed to
be mounted to a bare 8" concrete or 8"x8"x16" concrete
block wall with NO wall covering!
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before drilling or installing
fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
5.
Drill one 3/8" (9.5mm) pilot hole with a depth of 3 1/2"
(88.9mm) at each marking. (See Figure 3)
6.
Install a UX10 anchor (N) into each pilot hole using a
hammer, making sure that the anchor is flush with the wall.
(See Figure 3)
NOTE:
If desired CPU location is off to the side of the display,
reverse brackets (A and B) from how they are shown in
Figure 3.
7.
Use two 5/16 x 2-1/2" lag bolts (M) and two 5/16" flat
washers (G) to attach top of brackets (A and B) to anchors
in wall. (See Figure 3)
8.
Mark the attachment points for the lower mounting slots.
(See Figure 3)
9.
Drill one 3/8" (9.5mm) pilot hole with a depth of 3 1/2"
(88.9mm) for each mounting hole. (See Figure 3)
10. Install a UX10 anchor (N) into each pilot hole using a
hammer.
11. Use two 5/16 x 2-1/2" lag bolts (M) and two 5/16" flat
washers (G) to attach the brackets to the wall through the
lower mounting holes. (See Figure 3)
Figure 3
Installing Shelf to Brackets
1.
Hang shelf bracket (C) onto right wall bracket (B). (See
Figure 4)
Figure 4
8
5
6
4
9
x4
(N) x 4
10
7 11
(M) x 4
(G) x 4
(A)*
(B)*
*reverse brackets to install CPU shelf to the outside
(C)
(B)
