![background image](http://html.mh-extra.com/html/chief/egx-sf2/egx-sf2_installation-instructions-manual_2601100010.webp)
EGX-SF2
Installation Instructions
10
8.
Replace the outlet box into the EGX-SF2 housing. (See
Figure 13)
9.
Rotate outlet box clockwise until it is in proper position to be
secured to the EGX-SF2 housing.
10. Tighten two Phillips screws to secure outlet box to EGX-
SF2 housing. (See Figure 13)
Figure 13
11. Install one clip (C) onto opposite side of EGX-SF2 from
where the new work clip is installed. (See Figure 14)
Figure 14
12. Tighten screw on the drywall clamp so that it is locked in
place against the drywall, and not laying flat against the
EGX-SF2. (See Figure 14)
13. Remove Phillips flat head screw and locking washer from in
between outlets. (See Figure 15)
Figure 15
14. Install faceplate (B) onto EGX-SF2 using one Phillips flat
head screw and locking washer removed in Step 5. (See
Figure 16)
NOTE:
Make sure LED light on outlet box lines up with hole
location on faceplate (B). (See Figure 16)
Figure 16
Outlet Box Use
NOTE:
The “PROTECTED” light indicates that the surge
protection circuitry is active and operational. (See
Figure 17)
Figure 17
9
10
x2
8
(C)
12
13
14
(removed screw and
(B)
LED light
washer) x 1
“PROTECTED”
indicator light