CM4
Installation Instructions
8
WARNING:
DISPLAY MAY WEIGH IN EXCESS OF
40 LBS (18.14 KG)! Always use two people and proper lifting
techniques when installing or positioning display.
1.
Attach interface bracket to back of display following
instructions included with the interface bracket.
2.
While supporting each side of display, align four mounting
buttons on display or interface bracket with four teardrop
slots on CM4. (See Figure 10)
3.
Lower display into place making sure recessed area of
mounting buttons are properly seated in lower area of
teardrop mounting holes. (See Figure 10)
4.
Secure display to CM4 by moving the "Q-Latch" into the
"latched" position. (See Figure 10)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Make sure
mounting buttons fully engage in teardrop mounting holes.
Figure 10
Attaching Left and Right Speakers
The method for attaching speakers is determined by the display
size and the amount of desired speaker extension.
CAUTION:
The individual weight of each left/right (end)
speaker attached to the CM4 must not exceed 18 lbs
(8.16 kg) each.
NOTE:
Figure 11 illustrates a bracket attachment for a 42"
display (most likely the smallest display used on the
CM4). A smaller display would allow the mount to show
from behind the display.
NOTE:
Figure 12 illustrates the bracket attachment for a larger
display and for the maximum speaker extension of
approximately 9 feet (2.74 m).
NOTE:
Installer may need to move speaker arms apart to
allow room for speaker installation. Pull one arm slowly
until adequate space is available.
Figure 11
Figure 12
1.
After determining the bracket attachment method
necessary for speaker installation, attach the bracket (K) to
the speaker using hardware specified by speaker
installation instructions and two optional rubber washers (F)
for each speaker. (See Figure 13)
NOTE:
If the speaker holes do not match the bracket screw
holes, refer to the speaker installation instructions for
further information on attaching the brackets to the
speakers.
2
3
1
Teardrop
Mounting Holes
Display
4
CM4
Speaker
Arm
(Front View)
(K)
CM4
Speaker
Arm
(Front View)
(K)