Chicco 06626, Instructions For Use Manual, Page: 41 / 268

40 41
The
parent
unit (re-
ceiver)
display
does not
show
any
image
(black
screen)
Absence of or loss of link
with Baby unit.
- The voice activation func-
tion has been selected.
- The parent unit (receiver)
may be off.
- If the display shows the
•
icon, move
units closer together and/or relocate the
units themselves in order to reduce the
number of obstacles, metal structures,
reinforced concrete walls, etc. interposed
between them and/or check that the
Baby unit is on.
- If the display shows the icon and
selector is set to ON, the voice activation
function is active.
As soon as sounds present in the Baby
unit environment exceed the threshold
for voice activation, the parent unit will
emit sounds and will display an image of
the baby again in real time.
- Switch on the parent unit (receiver).
Image
colours
on the
display
are very
light
- Too much display bright-
ness.
- Press the key (15) until you find the
desired level of brightness.
Image
colours
on the
display
are very
dark
- Too little display bright-
ness.
- Night vision activated.
- Press the key (15) until you find the
desired level of brightness.
- Check the lighting conditions of the
room where the Baby unit is located.
If the room is dark or in low light condi-
tions, alteration of image colour on the
display is to be considered normal.
Interfer-
ence
- In rare cases, even if
HOPPING technology en-
sures high immunity to in-
terference from analogue
devices, interference can
be caused by the presence
of another intercom or
similar transmission device
switched on nearby or by
electromagnetic pollution
(proximity to antennas
with radio transmitters,
high voltage cables, etc.).
Move away from analogue equipment
and/or leave the area in which it is
located.