Chicco 06626, Instructions For Use Manual, Page: 33 / 268

32 33
-Indication that Alkaline batteries are
almost flat:
the indicator light (12) will light up red
and begin to flash.
- Alkaline batteries charged or opera-
tion via mains adapter (1):
the indicator light (12) will switch off.
Night Vision
In case of darkness or decrease in the
brightness of the room where the Baby
unit is located, the light-sensitive sen-
sor (8) will automatically activate the
infrared lighting system (7) to allow
viewing of the baby even in the dark.
Attention:
When night vision is active, the parent
unit display (4) image colours will be
altered and, in the event of darkness,
the images will appear in black and
white: this is to be considered normal.
2.2 Parent unit (primarily in receiver
mode of images and sounds)
2.2.1 Power and recharging:
Power via supplied rechargeable 3.7V,
1800mAh (13) lithium-ion battery
or via 100-240V~, 50/60Hz /6.5V
, 550mA (1) mains switching
adapter.
ATTENTION: The charging of re-
chargeable batteries should only be
done via the supplied mains adapter
(1) and can be performed both if the
parent unit is switched on and if the
parent unit is off.
In the event of power with mains
adapter (1) or rechargeable lithium-
ion battery charging:
- verify that the voltage corresponds
to the rating plate of the previously
indicated adapters.
- insert the mains adapter jack (1) in
the power connector (14) on the side
of the unit.
- insert the mains adapter plug in an
easily accessible power socket.
Attention:
- The mains adapter cord (1) may con-
stitute a risk of strangulation, keep out
of reach of children.
- Periodically inspect mains adapters
(1). If the power cord or plastic parts
show signs of damage, do not use
them and contact a qualified techni-
cian.
- Do not leave mains adapters (1)
plugged into the outlet when devices
are not in use and/or not connected to
the mains adapters (1)
2.2.2 Modes of use - Switching on
and Adjustment
Switching on/off the parent unit (pri-
marily in receiver mode of images and
sounds)
Press the on/off button (2) for about
2 second. The parent unit (primarily in
receiver mode of images and sounds)
will switch on. The power and link
indicator light (8) will begin to flash
green and the display (4), after briefly
displaying the Chicco logo, will show
the icon
•
to indicate that the parent
unit is searching for a connection with
the Baby unit. Once connection has
been established between the 2 units,
the icon will be shown, the link in-
dicator light (8) will light up a steady
green and the image detected in real
time by the camera (5) on the Baby
unit will be shown.
Keep the button (2) pressed for 2 sec-
onds until the power and link indica-
tor (8) and the parent unit (primar-