Page 5
For technical questions, please call 1-800-444-3353.
SKU 47423
REV 05k
previously aligned holes in the plywood board and Trailer frame. Insert two Bolts (6)
downward through the holes in the front Panel, plywood board, and Trailer frame. Then,
screw on a Nut (7) to each of the two Bolts extending through the underside of the Trailer
frame. Do not fully tighten the Nuts in this Step.
(See Figure c.)
Place one Side Panel (2) on one side of the Trailer and underneath the plywood board.
5.
Slide the Side Panel forward into the “lip” of the front Panel (1), and make sure to align
the
four
mounting holes at the bottom of the Side Panel with the previously aligned holes
in the plywood board and Trailer frame. Insert four Bolts (6) downward through the holes
in the Side Panel, plywood board, and Trailer frame. Then, screw a Nut (7) onto each of
the four Bolts extending through the underside of the Trailer frame. Do not fully tighten
the Nuts in this Step.
(See Figure c.)
Repeat Step #5 for the remaining Side Panel (2).
6.
(See Figure c.)
Align the
7.
four
mounting holes on one side of the front Panel (1) with the four mounting
holes on the front end of one Side Panel (2). Insert four Bolts (8) through the four
mounting holes on the side of the front Panel and through the four mounting holes on the
front end of the Side Panel. Then, screw a Nut (9) onto each of the four Bolts extending
through the inner side of the Side Panel. Do not fully tighten the Nuts in this Step.
(See
Figure c.)
Repeat Step #7 for the other side of the front Panel (1) and remaining Side Panel (2).
8.
(See Figure c.)
Check to make sure the Steel Side Panel Kit is setting square on the Trailer.
9.
Then,
firmly wrench tighten all Bolts and Nuts.
(See Figure c.)
