Page 4
For technical questions, please call 1-800-444-3353.
SKU 47423
PRODUcT OVERVIEW
The Steel Side Panel Kit is designed
for use only with the
Model 42709 Trailer
(available from harbor freight Tools). Its
assembly onto the Trailer requires a
3/4”
thick, 4’ x 8’ plywood board
(not provided)
.
Attaching the Steel Side Panel Kit to the
Trailer will also require drilling
mounting
holes
through the plywood board.
ONLY A
QUALIFIED
TEcHNIcIAN SHOULD PERFORM THE AS-
SEMBLY.
ASSEMBLY INSTRUcTIONS
NOTE:
for additional references to the parts
listed below, refer to the
Assembly
Diagram
(page 9).
1. Measure the on-center distance between
the ten mounting holes located on the
front frame and two side frames of the
Trailer, locations indicated above.
DRILL 3/8” hOLES
FIgURE A
notch
notch
2. Use the measurements taken in Step #1
to mark and drill ten holes through the
3/4” thick, 4’ x 8’ plywood board.
(See
Figure A.)
NOTE: You will need to notch out the
plywood to allow for the hinge as
shown in Figure A.
ALIGN PRE-DRILLED
hOLES IN PLYwOOD
wITh fRAME
MOUNTING hOLES
3/4”, 4’x 8’
PLYwOOD
BOARD
MODEL
42709
TRAILER
FIgURE B
3.
With assistance,
place the 3/4” thick, 4’
x 8’ plywood board on the frame of the
Trailer. Make sure to align the ten pre-
drilled holes in the plywood board with
the ten mounting holes on the front and
two sides of the Trailer frame.
(See Figure B.)
Place the front Panel (1) on the front
4.
of the front end of the Trailer and
underneath the plywood board. Make
sure to align the
two
mounting holes at
the bottom of the front Panel with the
