3.
IF YOU USE AN EXTENSION CORD, MAKE SURE TO USE ONLY UL
APPROVED CORDS HAVING THE CORRECT GAUGE AND LENGTH.
(SEE FIGURE A.)
REQUIRED EXTENSION CORD GAUGE
Namep late
Extension C ord Length
Amp eres
25’
50’
75’
100’
150’
200’
0 - 5
16
16
16
14
12
12
5.1 - 8
16
16
14
12
10
-
8.1 - 12
14
14
12
10
-
-
12.1 - 15
12
12
10
10
-
-
15.1 - 20
10
10
10
-
-
-
FIGURE A
4.
MAINTAIN A SAFE WORK ENVIRONMENT. Do not use this tool in or near
damp or wet areas. Do not expose this product to rain. Keep work area well lit.
Make sure there is adequate surrounding work space. Use this tool in a well
ventilated area. Do not operate this tool in the presence of flammable liquids,
gases, or dust. To avoid accidental electric shock, do not let your body come in
contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators.
5.
DO NOT FORCE THE EQUIPMENT. This Polisher/Sander will do the work better
and safer at the speed and capacity for which it was designed.
6.
REMOVE ALL ADJUSTING WRENCHES FROM THE POLISHER/SANDER
BEFORE TURNING IT ON.
7.
AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin
work before turning the Power Switch (part #33) “ON”.
8.
ALLOW THE POLISHING DISC (part #44) AND WOOL COVER (part #45), AS
WELL AS THE RUBBER BACKING PLATE (#46) WHEN SANDING, TO SPIN
UP TO FULL SPEED BEFORE PRESSING THEM ONTO THE WORKPIECE.
When turning off the Polisher/Sander, allow the Rubber Backing Plate or Polish-
ing Disc to spin down and stop on their own. Do not press against to stop them.
9.
DO NOT FORCE THE POLISHING DISC (part #44) AND WOOL COVER (part
#45), RUBBER BACKING PLATE (#46) WITH SANDPAPER DISC ONTO THE
WORKPIECE WHEN USING. Apply moderate pressure, allowing the Polisher/
Sander to do the work without being forced.
10.
MAKE SURE THE WORKPIECE IS FREE FROM BURRS AND ANY OTHER
FOREIGN OBJECTS WHICH COULD DAMAGE THE POLISHER/SANDER.
SKU 46507
PAGE 4
