SKU 94434
For technical questions, please call 1-800-444-3353
PAGE 8
NOTE:
While charging, the Battery Pack (22) and Charger (26) may become warm
to the touch. This is normal, and does not indicate a problem.
(See Figure A.)
Once the Battery Pack (22) is fully charged, disconnect the Charger (26) from the
electrical outlet. Then, disconnect the Charger from the Battery Pack.
(See Figure A.)
OPERATING INSTRUCTIONS
If possible, install the Side Handle (21) to allow better control of the drill. If desired,
insert the Depth Gauge (25) through the hole in the Side Handle. The Depth Gauge
(25) allows you to drill a hole to a specific depth.
When installing Drill Bits, make sure the Battery Pack (22) is removed from the
Cordless Drill to avoid accidental starting. Then, insert and lock in place a Drill Bit
in the Chuck (11) of the Cordless Drill.
Whenever possible, secure the workpiece in place, using a vise or clamps (not
included).
When drilling in light gauge metal or wood, use a wooden block to back up the
material to prevent damage to the workpiece.
Mark the center of the hole to be drilled with a center punch to give a Drill Bit a start
and to prevent it from “walking”.
Lubricate the Drill Bit with cutting oil when drilling iron or steel. Use a coolant when
drilling nonferrous metals such as copper, brass, or aluminum.
BATTERY PACk (22)
HANDLE
FIGURE B
Insert the fully charged Battery Pack (22) into the Handle of the Cordless Drill.
(See Figure B.)
5.
6.
1.
2.
3.
4.
5.
6.
7.
