SKU 91995
For technical questions, please call 1-800-444-3353.
Page 14
BASIC OPERATION
WARNINg! Make sure the Power
Cord (102) of the Miter Saw is un-
plugged from its electrical outlet.
Then, if necessary, make adjustments
to the workpiece Holder (9), cutting
depth, miter angle, and bevel angle.
Raise the Saw Blade (56) up to allow
1.
positioning of the workpiece.
Check to make sure the Trigger (98)
2.
is operating properly.
Place the workpiece on the Table
3.
(18a) and against the Guide Fence
(37a).
Use the Clamp Assembly (36) to hold
4.
the workpiece in place.
Plug the Power Cord (102) into the
5.
nearest 120 volt, grounded, electri-
cal outlet.
Squeeze the Trigger (98) to turn on
6.
the Miter Saw.
When the Saw Blade (56) is turning
7.
at full speed, slowly bring down the
Motor Housing (75) to complete the
cut.
Note:
Feed the Saw Blade into the work-
piece
gradually
. Do not force the
machine to remove material faster
than it was designed to cut.
When cutting a large workpiece,
8.
make sure its entire length is properly
supported. If necessary, use a roller
stand (not included) with a larger
workpiece.
Never attempt to remove material
9.
stuck in the moving parts of the Miter
Saw while it is plugged in and run-
ning.
Turn off the Miter Saw if the work-
10.
piece is to be backed out of an un-
completed cut.
When the cut is complete, release the
11.
Trigger (98) to turn off the Miter Saw.
Wait until the Saw Blade (56) comes
12.
to a complete stop. Raise the Mo-
tor Housing (75).
Then, unplug the
Power Cord (102) from its electri-
cal outlet.
Loosen the Clamp Assembly (36),
13.
and remove the workpiece and scrap
material from the Table (18a).
