Page 9
For technical questions, please call 1-800-444-3353.
SKU 68856
Charging Instructions
1. Plug the charger into a grounded, 120 V~, 60 Hz
outlet. Do not use an extension cord. The Green
LED will light to show the power is connected.
Battery Pack
Red
LED Green
LED
Charger
Figure A: Charger Indicators
2. Slide the Battery Pack into the charger until the
button on the Battery Pack clicks into place. The
Red LED will flash to show the Battery is charging
and the Green LED will continue to stay lit.
Note:
If the Battery does not fit properly, disconnect it
and confirm that the Battery Pack is the correct model
for this Charger as shown on the Specification chart.
Do not charge any other Battery Pack or any Battery
Pack that does not securely fit the Charger.
3. Frequently monitor the Charger and
battery pack while connected.
4. For a fully discharged battery or a new battery, allow
the Battery Pack to Charge for 1 hour.
The Red and Green LED’s will stay on (not
flash) when the battery is finished charging.
5. Unplug the Charger and disconnect it from
the Battery Pack when finished.
6. Allow the Battery Pack to cool
completely before using it.
7. Store the Charger and Battery Pack
indoors, out of reach of children.
Operating the Drill Driver
1. Insert the fully charged Battery Pack (11) into the base
of the Drill Driver, making sure that it clicks into place
securely. Be sure the Battery Pack is securely seated
into the Drill Handle so it does not fall off during use.
2. Slide the Direction Switch (which should initially be
centered in the “lock” position) to the right for forward
drilling/fastening, or to the left for reversing the
operation. Use the “reverse” setting only to remove
screws or to release a jammed drill bit.
WARNING! Do not change direction of rotation
while Chuck is rotating.
Wait until Chuck has come
to a complete stop before changing direction.
3. If using the Drill to insert or remove screws, position
the driver tip in the item to insert or remove.
4. If drilling a hole, hold the Drill above the area to drill.
5. Press the Trigger to start the drill. The Work
Light will also activate once the Switch is
pressed and turn off once Switch is released.
6. When inserting or removing a screw or bolt, use
slight pressure at first to keep the screw driver bit in
the head of the screw or bolt and cause the screw
or bolt to thread into or unthread from the material.
7. When drilling a hole, let the Drill do the work,
using only enough pressure to follow the
drill as it cuts the hole in the material.
8. When drilling a hard, smooth surface, use a center
punch (not included) to mark the desired hole. This will
prevent the drill bit from slipping as the hole is started.
9. When finished using the Drill, release the Trigger
and center the Direction Switch to lock the
trigger mechanism as a safety measure.
10. Remove the Battery Pack.
11. Clean then store the Drill indoors
and out of children’s reach.
Wood Drilling Tips
1. For best performance, use high speed drill bits for
wood drilling and turn the torque setting to the drill icon.
2. Start wood drilling at very low speed
to keep the bit from slipping. Increase
speed as drill bit bites into wood.
3. When drilling through holes, place a block or
wood behind the workpiece to prevent ragged
edges on the back side of the hole.
Metal Drilling Tips
1. For best performance, use high speed
drill bits for metal or steel drilling and turn
the torque setting to the drill icon.
