SKU 66006
For technical questions, please call 1-800-444-3353.
Page 10
SpeciFicatiOnS
Motor
18V DC
Electrical Requirements
18V Lithium-Ion Battery
Motor No Load Speed
2-Speed
High - 0-1400 RPM
Low - 0-400 RPM
Clutch System
24-Torque Settings
Chuck Capacity
1/2" Keyless
Charger Input
120V, 60Hz AC only
Optimum Charging
Temperature
32°F - 104°F
Charging Cycles
3x-4x More Than Ni-
Cads
Self-Discharge
Up To 5x Lower Than
Ni-Cads
unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
inStructiOnS FOr
putting intO uSe
read the entire impOrtant
SaFetY inFOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO preVent
SeriOuS injurY
FrOm accidental
OperatiOn:
turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Operating inStructiOnS
read the entire impOrtant
SaFetY inFOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tool Set up
tO preVent
SeriOuS injurY
FrOm accidental
OperatiOn:
turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
work piece and work area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Secure loose work pieces using a
2.
vise or clamps (not included) to pre-
vent movement while working.
There must not be hazardous ob
-
3.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.