SKU 45005
For technical questions, please call 1-800-444-3353.
Page 9
MAinTEnAnCE
Using a clean cloth, wipe the Cable Clamps and charger of all grease and dirt.
1.
Coil all cables.
2.
Store the Battery Charger in a clean and dry location.
3.
If any cable insulation becomes cracked and exposes copper wire, have it repaired
4.
or replaced by a qualified technician.
Troubleshooting
Problem
Possible Causes
Likely Solutions
Maximum ammeter
reading
Defective battery
Check and/or replace battery
No ammeter
reading
No power to charger
1.
Battery cable clamps not connected to
2.
battery properly
Defective battery
3.
Check power cable and outlet
1.
connections
Clean battery terminals and reset
2.
cable clamps
Check and/or replace battery
3.
Charging current
not to full output
Battery is partially charged
1.
Defective battery, will not hold full
2.
charge
Continue charging
1.
Check and/or replace battery
2.
Ammeter needle
moves up to full
charge, then drops
to zero. Makes
clicking noise.
Battery is completely dead
1.
Defective battery
2.
Charger is resetting itself after circuit
3.
breaker overload
Continue charging battery.
1.
Charger will continue to reset itself
until the battery charge reaches a
chargeable level.
Check and/or replace battery
2.
Wait until charger automatically
3.
resets itself.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
note:
No replacement parts are available for the Battery Charger.