13
Q-1002(VHF)
RF HAND-HELD Microphone
Color cap
Battery status
LED indicator
Metal Grille
( Capsule module inside )
Handheld Microphone
Parts and Functions
Power Switch
Battery compartment
cover
Press
Battery Installation
Q-1002 uses 1 piece of 9V battery. To install new or replace the old battery, First unscrew the battery cap from the
battery compartment, then insert the new battery according to its correct polarity as indicated. For longer
Operation hour, Alkaline battery is recommended!
slide to "ON" position
Fig. 1
After putting the battery cover back to the housing , slide the switch to "ON" position as shown in Fig.1
As soon as the power is on, the battery-status indicator will give flash, indicating a
normal operation. If there is no flash, it indicates either power supply is not
available or battery is installed wrongly.
After switching on, the Therefore signal indicator LED(s) of matching receiver will
light up, indicating the microphone signal transmission is in normal operation.
Switch off the power when the microphone is not in use, meanwhile, remove the
battery out of microphone if it is not to be used for an extended period.
10
3-5
Recording
3-6
Playing
3-7
ll
Pause
3-8 DEL.: Delete file
3-9 A-B: A-B repeat
3-10 Repeat
3-11 Repeat All
3-12 LINE IN: Line in audio source is available
3-13 Connecting to PC through USB
3-14
Track no.
3-15
:
Time counting
3-16 F: Using flash memory
3-17 C: Using SD card
&
4-2 Upper key: Upper key for track selection. Track number will move quickly when push still for
two seconds (this function will not work in MP3 mode).
4-3 Down key: Down key for track selection. Track number will move quickly when push still for two
seconds (this function will not work in MP3 mode).
4-4 REC key: Record key. Select track no. in VOC mode in advance, push REC key to record, then
push key to stop record. If the track you want to record is occupied, the LCD will
show "
" you must delete the content of the track before you record. When the
memory is with 30 seconds left, the CD will start to count 30,29,28,27.....,5,4,3,2,1,0
You can use microphones LINE IN audio source or both mixed source for recording
source.
4-5 Play/ II key: Play key. Select the track no. you want to play, then push PLAY key to play. Push
PLAY key during playing will pause play, then push PLAY key again to start playing.
Push STOP Key to stop play.
4-6 key: STOP key. Push the key to stop all the motions, ex.: recording, playing, track selection.
4-7 key: Forward key. The playing will move forward when press the key, back to normal speed
when release the key.
4-8 key: Rewind Key. The playing will move rewind when press the key, back to normal speed
when release the key.
4-9 A-B repeat key: During playing, push this key to indicate any point as start point (A point) and
finish point(B point) on a track, the machine will repeat from A to B point until you
push the key again to release the function and continue to play.
4-10 Repeat key: In MP3 mode during playing, push REPEAT key once to"epeat the
track" the LCD will show , and push REPEAT key twice to"repeat
all the track" , the LCD will show . Push the key at the third time to
release repeat function. The "Repeat all " function can not be used
In VOC mode.
4. Key control
4-1 Power key
