Chevrolet 2008 T Series, Owner'S Manual

Page: 116 / 298

Using the Alarm
#
(Alarm): The alarm on the radio can be used to
activate an alarm at a desired time.
To set the alarm, perform the following:
1. Press this button until the alarm symbol displays.
2. Press again until the display flashes.
3. Press the up tuning arrow to change the hour.
4. Press the down tuning arrow to change the minutes.
After setting the alarm, the display changes back to
the current time.
5. Press the alarm button again and the alarm
symbol displays. The alarm sounds at the
same time every day.
6. To turn the alarm off, press the alarm button.
7. To deactivate the alarm, press the alarm button.
To check the time of the alarm, press the
#
button.
Playing a CD
Insert a CD partway into the slot, label side up. The
player pulls it in and the CD should begin playing.
If the ignition or radio is turned off with the CD in the
player, it stays in the player. When the ignition or radio is
turned on, the CD starts playing where it stopped, if it
was the last selected audio source.
When a CD is inserted, the CD symbol displays. As
each new track starts to play, the track number displays.
The CD player can play the smaller 3 inch (8 cm)
single CDs with an adapter ring. Full-size CDs and the
smaller CDs are loaded in the same manner.
Care of Your CDs
If playing a CD-R, the sound quality can be reduced due
to CD-R quality, the method of recording, the quality of
the music that has been recorded, and the way the CD-R
has been handled. Handle them carefully. Store CD-R(s)
in their original cases or other protective cases and away
from direct sunlight and dust. The CD player scans the
bottom surface of the disc. If the surface of a CD is
damaged, such as cracked, broken, or scratched, the CD
does not play properly or not at all. Do not touch the
bottom side of a CD while handling it; this could damage
the surface. Pick up CDs by grasping the outer edges or
the edge of the hole and the outer edge.
3-42