Chemtrac Auto Clean UV254, Owner'S Manual, Page: 20 / 41

Chemtrac UV254 Monitor
– UVM5000 v 2.1
Chemtrac, Inc. 19
MENU ITEM DESCRIPTION
CLEANING SYSTEM
Enable Clean
Press ‘Enter’ then up/down to select 0 or 1 to turn on automatic cleaning system if
supplied (Default = 0)
Reset Clean
Press
‘Enter’ then up/down to select 0 or 1 to reset fluid alarms after refilling fluid
(Default = 0)
Force Clean
Press ‘Enter’ then up/down to select 0 or 1 to force the cleaning system to begin a
cleaning cycle (Default = 0)
Pumping Time Operator configurable. Enter a number between 90 and 180 seconds.
CLEAN FREQUENCY
0: No Cleaning
1: 4 hours
2: 12 hours
3: 24 hours
4: 3 days
5: 1 week
6: 2 weeks
7: 1 month
Select
Press ‘Enter’ then up/down to select cleaning frequency 0 - 7 (Default = 4: 3 days)
ROTATION
On: 1 Off: 0
Select
Press ‘Enter’ then up/down to turn on/off the rotating arm (Default = 1: On)
REF POSITION *Factory settings
Steps
Press ‘Enter’ then up/down to change motor alignment, increasing the # adjusts the
position clockwise
RS-232 DATA LOG
Setup
Baud Rate: 9600 Fixed parameters for RS-232 logging
Parity : none Fixed parameters for RS-232 logging
Stop Bits : 1 Fixed parameters for RS-232 logging
Flow Ctrl : none Fixed parameters for RS-232 logging
Data for Log
Add:1 Remove:0
Sensors
Press ‘Enter’ then up/down to select all lamp and water sensor data (Default = 0)
Temp/Humid
Press ‘Enter’ then up/down to select cabinet temp and humidity data (Default = 0)
UVT
Press ‘Enter’ then up/down to select UVT data (Default = 1)
UVA
Press ‘Enter’ then up/down to select UVA data (Default = 0)
Crltn.
Press ‘Enter’ then up/down to select correlation data (Default = 0)
Status
Press ‘Enter’ then up/down to select status code for alarms & diagnostics (Default = 0)
* Factory setting - unit specific value set at factory. Value can be located on the label on the inside of the cabinet
door.