6
the documents, make a precise report on the damage to the machine. Do
not
overturn the package!! When transporting it make sure that it is firmly held
by the four corners
(keeping it parallel to the floor).
All operations must be carried out by spe-
cialized personnel (Fig. n°9).
WARNING!
2.1 - UNPACKING
Remove the straps from the package (Fig.
n°10) and lift the cardboard (h).
The package should be:
a) the machine on the pallet (Fig. n°11 de-
tail a);
b) blade extractor (Fig. n°11 detail b);
c) 4 feet (Fig. n°11 detail c);
d) Case, if present (Fig. n°11 detail d).
Check inside the suitcase if it present, find
the following components:
(Fig. n°11):
1. Instruction manual (detail 1) ;
2.
CE
compliance certificate (detail 2);
3. Audio-visual cd;
4. Liquid detergent with sprayer;
5. Oil tube;
6. Sharpening and burring grinders;
7. Socket wrench to remove grinders;
8. Grinders brush;
9. Large and small screwdrivers.
10. Pliers.
CHAP. 2 - INSTALLATION
Fig. n°9
Fig. n°10
h
a
b
c
d
2
1
Fig. n°11
19
5.3 - SHARPENING THE BLADE
1. disinsert the plug from the outlet and
carefully clean the blade with denatured
alcohol so it is degreased;
2. lift (a) the sharpener cap (1) and turn it
180° (b Fig. n°42);
WARNING: Before starting to sharpen the blade, pay attention to RESIDUAL RISKS
(chapter 4.2.2) concerning the dangers of cutting without having followed the in-
structions listed below.
To sharpen the blade, which needs to be done periodically as soon a decrease
in cutting is noticed, the following directions must be adhe-
red to:
3. let it go in a way that the cap (c) fits on
the locator pins (d Fig. n°43);
4. check also that the blade stays between
the two grinders;
5. insert the pin and start the machine, by
pressing the “ON” push-button;
6. press the push-button (2 Fig.n°44), let
the blade rotate in contact with the grin-
der for about 30/40 sec. so that a slight
burr forms on the blade edge;
7. press the 2 push-buttons (2 and 3) con-
temporaneously for 1/2 sec. and relea-
se them in the same instant (Fig. n°45);
8. after having completed the sharpening it
is advisable to clean the grinders and
the blade (
chapter 6.2.3
);
9. once the operation is finished, replace
the sharpening device in its original
position, doing the procedure in reverse.
N.B.: Do not carry on the deburring
operation for more than 1/2 sec. to
avoid the damaging bending of the blade
edge.
b
a
1
Fig. n°42
Fig. n°43
Fig. n°44
c
d
2
3
2
Fig. n°45
