Checkpoint Systems, Inc.
– Field Service Installation Document – CKP P/N
#######
Page 2 of 9
Main System I/O and UHF Ports for TX/RX Antenna
Tx/Rx Utilization of UHF Ports
“Rule of 3” - the coax connectors used that will have cables routed to the same
pedestal will always be spaced 3 connectors apart (i.e. 4th connector away from
RX3 is used for RX4 in at the connector labeled 2 above)
For other aisle configurations, refer to Installation Manual or procedures below.
1
RFID Coax Connector Side (“top”)
2
“Side Panel” with 4-Pin Digital Input,
Serial Port via RJ-45 and LTS/SND
(covered in the GPIO section)
3
Ethernet Port - see Client Network
connection
4
IN - Interped communication
5
OUT - Interped communication
6
+12V DC Power Input conn.
Standard Single Aisle:
UHF Ports
numbered to match RX Patch wiring
Patch inside
Active Ped.
Patch inside any
neighboring Ped.
1
RX 2
-
2
-
RX 4
3
-
-
4
-
-
5
RX 1
-
6
-
RX 3
7
-
-
8
-
-
