Check Point Quantum Spark 1570R, Getting Starded Manual

Page: 26 / 78

Front Panel
Quantum Spark 1570R Appliance R80.20.XX Getting Started Guide | 26
Key Item Description
1 LEDs From top to bottom:
n
LTE
l
Cellular off - Off
l
Cellular modem available (operating SIM must be
inserted and activated) - Solid blue
l
Cellular data transfer - Blinking blue
l
Cellular modem issue (no SIM, modem off, no signal,
etc.) - Red
n
WiFi
l
WiFi off - Off
l
WiFi on and operates normally - Blue
l
Wifi error/alert - Red
n
Management
l
No management - Off
l
Colors - See below
n
Internet
l
No internet connection - Off
l
Connecting to the internet - Blinking blue
l
Connected - Blue
l
Connection failure - Blinking red
n
Power/Status
l
Normal operation - Solid blue
l
Boot in progress or installing firmware - Blinking blue
l
Error/Alert - Red
2 12-60V, -
48VDC input Connects to the power source cable from your power infrastructure.
3 Ground screw Protective earthing terminal.
4 Power cord
socket Plug the power adapter cord in here. Use only Check Point power adapters.
5 USB port 3.0 USB port 3.0 for software download.
6 Serial port Plug in the serial cable here (standard D59).
7 Console Plug in the USB Type-C serial console cable here. Baud rate: 115200.
8 LAN ports LAN ports 1-8. Port #2 is sync.
10/100/1000MbE.
9 WAN and DMZ
ports 10/100/1000MbE
WAN and DMZ ports support copper RJ45 and fiber interfaces.
For each port, only one interface is allowed to use.
In case that both the copper and fiber of the same port will be plugged, this
port will have un-stability issues.
Note - When using SFP, the ambient temperature is limited to 70 degree C.