Check Point Quantum Spark 1570R, Getting Starded Manual

Page: 9 / 78

Connecting the Cables
Quantum Spark 1570R Appliance R80.20.XX Getting Started Guide | 9
Connecting the Cables
1. Connect the power supply unit to the appliance and to a power outlet.
The appliance is turned on when the power supply is connected.
2. When the appliance is turned on, the Power LED on the front panel lights up in red for a short period.
The LED then turns blue and starts to blink. This shows a boot is in progress and firmware is being
installed.
When the LED turns a solid blue, the appliance is ready for login.
Note - The LED is red if there is an alert or error.
3. Connect the standard network cable to the LAN1 port and to the network adapter on your PC.
4. If you use an external modem:
Connect the Ethernet cable to the WAN port on the appliance back panel and plug it into your external
modem or router’s PC/LAN network port. The Internet LED on the appliance front panel lights up
when the Ethernet is connected.
For DSL appliances only: Connect the telephone cable to the DSL port on the appliance back panel
and plug it into the DSL line socket. The DSL LED as well as the Internet LED remains off until you
configure the appliance, including setting up the DSL as an internet connection.
Note - Wait 10 seconds between power cycles (off and on).