Step 9: SmartDashboard Configuration
Check Point 61000 Security System Getting Started Guide R75.40VS for 61000 | 63
11.
Click
Finish
.
The
General Properties
page of the 61000 Security System object opens.
12.
In the
General Properties
page, make sure the
Version
is correct.
13.
Enable the Firewall
Software Blade
. Enable other supported Software Blades as necessary.
14.
In the navigation tree, select
Topology
.
15.
Configure:
•
Interfaces as Internal or External
•
Anti-Spoofing.
Note
: Only data and management interfaces show in the list.
16.
Click
OK
.
The Security Gateway object closes.
17.
Install the Policy.
Confirming the Security Gateway Software Configuration
To make sure that the policy was successfully installed:
1.
Connect to the appliance with SSH or a serial console.
2.
Run:
# asg monitor
3.
Make sure that the SGM status is
Enforcing Security
on the ACTIVE and STANDBY Chassis.
4.
Make sure the
Policy Date
matches the date and time the policy was installed.
To verify the configuration:
After configuring the Security Gateway and installing the policy, validate the configuration using
the
asg diag
command ("
Collecting System Diagnostics (asg diag)
). Use the
command to collect and show diagnostic information about the system.
If there is a problem, fix it before using the system.
