3000 N 29
th
Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084, Fax (954) 929-5560
To gain access to the lamp you must first remove the following
two screws. The lamp cage is one piece and the MR16 lamp
cannot be removed unless you first remove the lamp cage.
STEP 3
Screws located opposite sides!
STEP 1
Slide MR16 lamp to free from retaining clips.
STEP 4
ART16CC Lamp Installation and Replacement
1. Check to make sure that the unit is cool and can be
handled! Wait 15 minutes after turning the fixture off
before lamp installation or replacement.
2. Remove the two cover screws as illustrated. If you are
replacing a lamp proceed to disconnect the lamp socket
from the lamp (MR-16 12V 50W).
3. WARNING! The lamp cannot be
removed from the cage. You must
first remove the two screws as
illustrated below and pull out the
lamp cage.
4. Once the lamp cage is pulled out,
proceed to slide the lamp out.
5. Replace with new lamp by sliding
the lamp into the lamp cage.
6. Place lamp cage back into the
fixture and replace screws.
7. Re-connect lamp socket to the lamp.
8. Replace fixture cover and screws to finish.
IMPORTANT INSTRUCTIONS!
Please note that the ART16CC comes pre-installed with a 12V 50W MR16 lamp therefore installation
may not be required on a new fixture. However, it is very important to follow the procedure detailed
below when it becomes necessary to replace the lamp.
