Page 8 of 31
Setup
Rogue R3 Beam User Manual Rev. 5
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
For our CHAUVET Professional line of mounting clamps, go to
.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which you are mounting the product can support the product’s
weight. See the
for weight information.
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to
reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the
desired angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the
knobs.
Procedure
The Rogue R3 Beam comes with a double-bracketed yoke to which you can either attach mounting
clamps for hanging or simply use as a floor stand. You must supply the mounting clamps. Make sure the
clamps are capable of supporting the weight of this product. Use at least one mounting point per product.
For the CHAUVET Professional line of mounting clamps, go to
http://www.trusst.com/products
.
Mounting Diagram
Omega bracket
Safety cable
(such as
CH-05
from
Chauvet)
Mounting clamp
(such as
CTC-50
or
CTC-50HCN
from Chauvet)
