Page 24 of 31
Operation
Rogue R3 Beam User Manual Rev. 5
Lamp Controls
This programming level allows the user to change a range of options that control the action of the lamp.
•
Starting from the
Setup
screen level, select
Lamp Settings
, press
<ENTER>
.
Lamp Settings
This option turns the lamp on and off.
1.
Highlight
On/Off
, press
<ENTER>
.
2.
Select
ON
or
OFF
, press
<ENTER>
.
Lamp State
This option determines whether the lamp turns on automatically when the product is powered up.
1.
Highlight
State/Power on
, press
<ENTER>
.
2.
Select
ON
or
OFF
, press
<ENTER>
.
Remote Turn Off
This option allows a connected DMX controller to turn the lamp on/off via the control channel.
1.
Highlight
Off Via Dmx
, press
<ENTER>
.
2.
Select
YES
or
NO
, press
<ENTER>
.
Lamp On if DMX Present
This option determines whether the lamp turns on automatically when a DMX signal is detected.
1.
Highlight
On If Dmx On
, press
<ENTER>
.
2.
Select
YES
or
NO
, press
<ENTER>
.
Lamp Off if DMX Absent
This option determines whether the lamp turns off automatically when a DMX signal is lost.
1.
Highlight
Off If Dmx Off
, press
<ENTER>
.
2.
Select
YES
or
NO
, press
<ENTER>
.
Lamp Strike Delay
This option sets the duration of time (seconds) it takes for the lamp to turn on when powering up the
product.
1.
Highlight
Ignition Delay
, press
<ENTER>
.
2.
Select
000–255
, press
<ENTER>
.
Lamp Low Power State
This attribute puts the lamp into a low power state when the shutters are closed helping to increase the life
of the shutters. This option allows the user to adjust how long from the instant the shutters are closed to
the time the lamp enter the low power state.
1.
Highlight
Low Power Delay
, press
<ENTER>
.
2.
Select
000–255
, press
<ENTER>
.
Lamp Timer
This procedure resets the lamp maintenance timer to
0
. It is recommended that this be done after every
lamp change.
1.
Highlight
Reset Lamp Time
, press
<ENTER>
.
2.
Select
YES
or
NO
, press
<ENTER>
.
•
Do not turn product on without a lamp!
•
ALWAYS turn the lamp off by using the DMX controller or the product’s control
panel, then wait at least 5 minutes before switching off the product. This will keep
the fans running to extract any remaining heat from the product’s head.
•
DO NOT power cycle the product unless it is necessary.
•
DO NOT re-strike the lamp immediately after turning it off. Chauvet recommends
waiting 5 minutes before trying to re-strike the lamp.
!
