REMOVAL & REPLACEMENT
39
SERVICING THE DOCKING STATION
Tools and equipment
•
#2 Phillips screwdriver
Before servicing the device, make sure that the mains
power plug is not connected to the docking station. The
servicing of the docking station must be done on a soft
material base.
1.
Take off the USB cable that links the tablet and
the subassembly and remove the tablet.
2.
Remove the two screws (M3x8) maintaining the
steel bottom and the top part of the docking
station subassembly. Use the #2 Phillips
screwdriver with an adequate screw torque.
3.
Return the docking and with the same
screwdriver, remove the three screws (M3.5x10)
maintaining the bottom part of the subassembly
to the bottom steel.
4.
Once that the screws are removed it’s possible
to separate the steel bottom and the docking
station subassembly.
NOTE: From this step, it’s possible to replace the docking
station tablet / subassembly or steel bottom as spare
parts.
Opening & disassembling of the docking
station
IMPORTANT:
Be sure that the USB cable is note
connected to the tablet.
1.
With the same screwdriver, remove the two
screws (M3.5X12.7) of the docking station front
bottom part. It’s then possible to open the
docking station subassembly.
Note: Final accessories may differ from the picture
