3D ActiveTrac
®
34
mAiNTENANCE
The electric powered 3D ActiveTrac Treatment Table is equipped with two maintenance free, 24-volt DC motors. The pneumatic pump
used in the traction unit is a diaphragm pump, which will give many years of trouble free service. Frequently check to make sure all
hardware (nuts, bolts, etc.) are securely fastened. Should any problems occur with this unit, contact your authorized 3D ActiveTrac
Dealer or call Chattanooga at 1-800-592-7329.
If the table is located in an area where it is subjected to extreme amounts of moisture or humidity, the swivel joints on the frame and
wheel casters should be lubricated occasionally with a good grade of machine oil.
CALiBrATiON
The 3D ActiveTrac should be calibrated by a qualified service technician every two years. Contact DJO, LLC for instructions.
CLEANiNg
The 3D ActiveTrac vinyl upholstery surface, the Pelvic and Thoracic Harnesses and Slimline Stabilization Belts, and the cervical
headstrap may be cleaned with a mild detergent or soap and water. For the table surfaces, apply the solution to a large area and
allow to soak for a few minutes. Brisk rubbing with a cloth should remove most dirt. Repeat the procedure in the case of stubborn
or embedded dirt. Rinse with clean water. A soft-bristle brush may also be used. The belts and harnesses should be hung to air dry.
Between patients, all surfaces should be cleaned using standard cleaning technique, paying particular attention to the components
that come in contact with the body.
EU Directive on Waste Electrical
and Electronic Equipment
(WEEE) ensures that product is
appropriately disposed of or
recycled at the end of its life.
