8
Getting Started
Tools Required
1.
Utility Knife
a.
For removing stretch wrap from around cabinet
2.
13 mm Socket Wrench
a.
For removing shipping brackets securing cabinet to pallet
3.
8 mm Socket Wrench
a.
For adjusting equipment mounting rails
4.
13 mm Open End Wrench
a.
For adjusting leveling feet
5.
#2 Phillips Screwdriver
a.
For adjusting leveling feet
b.
For installing screws to secure equipment in mounting rails
c.
For removing and installing door hinges
d.
For installing baying brackets
Unpacking
CAUTION
: The GT-Series GlobalFrame Gen 2 Cabinet is heavy. Use a minimum of
two (2) people to unpack and remove the cabinet from the pallet.
CAUTION:
The GT-Series GlobalFrame Gen 2 casters are for moving the cabinet short
distances over smooth floor surfaces only. Move shipping pallet as close as possible
to the final installation location before unpacking.
CAUTION:
The GT-Series GlobalFrame Gen 2 casters are not intended to support
cabinet loads. Always level and anchor the cabinet after positioning.
Inspect the cabinet for damage. If any damage to the cabinet is observed, contact your distributor or
CPI Customer Service.
