ATXP-965Q Technical Reference
Chapter 3 – AMIBIOS Setup
Chassis Plans
33
►
Super I/O Configuration Screen
Onboard Floppy Controller
Set this option to enable to enable the floppy drive controller
on the motherboard. The settings are Enabled and Disabled.
The default setting is enabled.
Serial Port Address
This option selects the base I/O port address of the serial port.
Available addresses are 3F8, 2F8, 3E8 and 2E8
Serial Port IRQ
This option selects the IRQ of the serial port.
Serial Port Mode
This option is only available for COM2 and allows the user to
configure the IR options
Parallel Port Address
This option selects the I/O address used by the parallel port.
Available options are Disabled, 378, 278 and 3BC
Parallel Port Mode
This option selects the parallel port mode. Available options
are Normal, SPP Bi-Dir, EPP+SPP, ECP and ECP+EPP
Parallel Port IRQ
This option selects the IRQ used by the parallel port. Available
options are 7 and 5
►
Hardware Health Configuration Screen
Shows information about temperatures and voltages and allows setting FAN parameter
H/W Health Function
Enable or Disable
PWM1 Mode Setting
Auto Fan Mode, Fan Always on Full, Fan Disable mode and
Manual mode
PWM1 Ramp Rate
The P64AX has 3 different Fans. The settings on this screen will control the functionality of all three if
the fans used 4 pin connectors
►
ACPI Configuration Screen
General ACPI Configuration
Suspend mode, Repose Video on S3
Resume
