13
Assemble the front guard and
clamp.
Fit the square bar into the hood
cover and lock it with the
thumbscrew.
Slide the vertical hold down onto the
square bar and lock it with the
thumb screw.
Fit the front spring guard into the
end of the square bar and lock it
with the thumb screw.
With these correctly set, the work
piece is held firmly against both the
table and the fence.
Never operate the spindle moulder
without them.
The end stop can be fitted as shown
into the T-slot on the sliding
carriage.
The angled shape makes it easier to
keep larger workpieces flat on the
table and suits rounded edges too.
The crosscut fence and work clamp
are assembled as shown.
Undo the main locking knob and the
ratchet handle. Slide the base
runner of the crosscut fence into the
T-slot in the sliding carriage.
The crosscut fence may be adjusted
up to 60 degrees in each direction.
There are preset stops at 90 and 45
degrees each way. It is locked in
place with the ratchet handle.
Pull the front pin out to move past
the preset stops.
